Sunday, 18 September 2022

Mapping Mountains – Summit Relocations – 30-99m Twmpau and Y Trechol – The Dominant Hills of Wales

 

Caer Lan (SN 314 179) 

There has been a Summit Relocation to a hill that is listed in the 30-99m Twmpau and Y Trechol – The Dominant Hills of Wales, with the summit height, bwlch height and their locations, the drop, dominance and status of the hill derived from LIDAR analysis conducted by Myrddyn Phillips. 

LIDAR image of Caer Lan (SN 314 179)

The criteria for the two listings that this summit relocation applies to are:

30-99m Twmpau - Welsh hills at or above 30m and below 100m in height that have 30m minimum drop, with an accompanying sub list entitled the 30-99m Sub-Twmpau, with the criteria for this sub category being all Welsh hills at or above 30m and below 100m in height with 20m or more and below 30m of drop, with the word Twmpau being an acronym standing for thirty welsh metre prominences and upward. 

The 30-99m Twmpau by Myrddyn Phillips

Y Trechol – The Dominant Hills of Wales – Welsh P30 hills whose prominence equal or exceed half that of their absolute height.  With the criteria for Lesser Dominant status being those additional Welsh P30 hills whose prominence is between one third and half that of their absolute height.  The list is authored by Myrddyn Phillips with the Introduction to the start of the Mapping Mountains publication of this list appearing on the 3rd December 2015, and the list is now available in its entirety on Mapping Mountains in Google Doc format. 

Y Trechol - The Dominant Hills of Wales by Myrddyn Phillips

The name the hill is now listed by is Caer Lan and this was derived from the Tithe map, and it is adjoined to the Mynydd Pencarreg group of hills, which are situated in the south-western part of South Wales (Region B, Sub-Region B1), and it is positioned with minor roads to its north, west and east, and the A40 road to its south, and has the small town of SanclĂȘr (St Clears) towards the west south-west.

When the original Welsh 30-99m P30 list was published on Geoff Crowder’s v-g.me website, this hill was listed with a summit height of c 75m, which is the uppermost Ordnance Survey map ring contour that appears on the 1:25,000 Explorer map.

When the sub list was standardised, and interpolated heights and drop values also included the details for this hill were re-assessed and it was listed with an estimated c 78m summit height positioned at SN 31418 17940, based on interpolation of its uppermost 75m map ring contour. 

Extract from the Ordnance Survey 1:25,000 Explorer map

However, it was not until LIDAR became available that the details for this hill could be accurately re-assessed.  The LIDAR (Light Detection & Ranging) technique produced highly accurate height data that is now freely available for much of England and Wales.

LIDAR analysis gives a 79.25m height positioned at SN 31377 17944 to ground on a raised field boundary as the highest on the hill, however protocols dictate that as this is deemed a relatively recent man-made construct such ground is discounted from the height of a hill. 

LIDAR summit image of Caer Lan (SN 314 179)

The height produced by LIDAR analysis to the natural summit of this hill is 78.8m positioned at SN 31408 17941, and this position in relation to the raised field boundary comes within the parameters of the Summit Relocations used within this page heading, these parameters are:

The term Summit Relocations applies to when the high point is positioned in a different field, to a different feature such as a conifer plantation, within a different map contour, a different point where a number of potential summit positions are within close proximity, when natural ground or the natural and intact summit is confirmed compared to a higher point such as a raised field boundary or covered reservoir that is considered a relatively recent man-made construct, or a relocation of approximately 100 metres or more in distance from either the position of a map spot height or from where the summit of the hill was previously thought to exist.

Therefore, the summit height produced by LIDAR analysis is 78.8m and this is to the remaining natural summit of the hill which is positioned at SN 31408 17941, this position is not given a spot height on the contemporary Ordnance Survey 1:50,000 Landranger and 1:25,000 Explorer map, and is approximately 30 metres eastward from where the high point of the raised field boundary is positioned. 

 

The full details for the hill are: 

Group:  Mynydd Pencarreg 

Name:  Caer Lan 

OS 1:50,000 map:  159

Summit Height:  78.8m (LIDAR) 

Summit Grid Reference (New Position):  SN 31408 17941 (LIDAR) 

Bwlch Height:  36.4m (LIDAR) 

Bwlch Grid Reference:  SN 30930 18268 (LIDAR) 

Drop:  42.4m (LIDAR) 

Dominance:  53.81% (LIDAR) 

 

Myrddyn Phillips (September 2022)

 

No comments:

Post a Comment