Crugiau Dwy (SN 171 311)
There has been a Summit Relocation to a hill that
is listed in the Y Trichant – The 300m
Hills of Wales, with the summit height, bwlch height and their locations,
the drop and status of the hill derived from LIDAR analysis conducted by
Myrddyn Phillips.
LIDAR image of Crugiau Dwy (SN 171 311) |
The criteria for the list that
this summit relocation applies to:
Y Trichant
– The 300m Hills of Wales – Welsh
hills at or above 300m and below 400m in height that have 30m minimum drop, with an accompanying sub list entitled the
Sub-Trichant, with the criteria for this sub category being all Welsh hills at
or above 300m and below 400m in height with 20m or more and below 30m of
drop. The list is authored by Myrddyn Phillips with the Introduction
to the list and the renaming of it appearing on Mapping Mountains on the 13th
May 2017, and the Introduction to the Mapping Mountains publication of the list
appearing on the 1st January 2022.
Y Trichant - The 300m Hills of Wales by Myrddyn Phillips |
The name the hill is listed by is Crugiau Dwy, and
it is adjoined to the Mynydd Preseli group of hills, which are situated in the south-western part of
South Wales (Region B, Sub-Region B1), and it is positioned with minor roads to its north and south-east, and
the A478 road to its east, and has the village of Crymych towards the north
north-east.
When the original 300m height band of Welsh P30 hills were published on Geoff Crowder’s v-g.me website, this hill was included
in the main P30 list with a 359m summit height, based on the spot height positioned
at SN 17141 31170 that appears on the contemporary Ordnance Survey 1:50,000
Landranger and 1:25,000 Explorer map.
Extract from the Ordnance Survey 1:25,000 Explorer map |
However, it was not until LIDAR became available
that the details for this hill could be accurately re-assessed. The LIDAR (Light Detection & Ranging)
technique produced highly accurate height data that is now freely available for
much of England and Wales.
LIDAR analysis gives the highest ground on this
hill as 360.45m positioned at SN 17148 31171 and SN 17150 31172. However, this is a part of a raised field
boundary and protocols dictate that as this is deemed a relatively recent
man-made construct such ground is discounted from the height of a hill.
LIDAR summit image of Crugiau Dwy (SN 171 311) |
The height produced by LIDAR analysis to the
natural summit of this hill is 360.3m positioned at SN 17129 31154 and SN
17133 31187, and this position in
relation to the raised field boundary comes within the parameters of the Summit Relocations
used within this page heading, these parameters are:
The term Summit Relocations applies when the high
point of the hill is found to be positioned; in a different field, to a
different feature such as in a conifer plantation, within a different map contour, to a different
point where a number of potential summit positions are within close proximity,
when natural ground or the natural and intact summit of a hill is confirmed
compared to a higher point such as a raised field boundary or covered reservoir
that is considered a relatively recent man-made construct, or a relocation of
approximately 100 metres or more in distance from either the position of a map
spot height or from where the summit of the hill was previously thought to
exist.
Therefore, the summit height produced by LIDAR
analysis is 360.3m and this is positioned at SN 17129 31154 and SN 17133 31187, this position is relatively close to where the 359m
spot height appears on the Ordnance Survey 1:25,000 Explorer map, and is
approximately 15 metres north-westward from where the high point of the raised
field boundary is positioned.
The full details for the hill are:
Group: Mynydd Preseli
Name: Crugiau Dwy
OS 1:50,000 map: 145
Summit Height: 360.3m (LIDAR)
Summit Grid Reference (New Position): SN 17129 31154 & SN 17133 31187 (LIDAR)
Bwlch Height: 321.5m (LIDAR)
Bwlch Grid Reference: SN 16431 30609 & SN 16432 30606 (LIDAR)
Drop: 38.8m (LIDAR)
Myrddyn Phillips
(October 2024)
No comments:
Post a Comment