Pen Llwyn Uchel (SN 517 387)
There has been a Summit Relocation to a hill that is listed in the Y Trichant – The 300m Hills of Wales, with the summit height, bwlch height and their locations, the drop and status of the hill derived from LIDAR analysis conducted by Myrddyn Phillips.
LIDAR image of Pen Llwyn Uchel (SN 517 387) |
The criteria for the list that this summit
relocation applies to are:
Y Trichant
– The 300m Hills of Wales – Welsh
hills at or above 300m and below 400m in height that have 30m minimum drop, with an accompanying sub list entitled the
Sub-Trichant, with the criteria for this sub category being all Welsh hills at
or above 300m and below 400m in height with 20m or more and below 30m of
drop. The list is authored by Myrddyn Phillips with the
Introduction to the list and the renaming of it appearing on Mapping Mountains
on the 13th May 2017, and the Introduction to the Mapping Mountains
publication of the list appearing on the 1st January 2022.
Y Trichant - The 300m Hills of Wales by Myrddyn Phillips |
The name the hill is listed by is Pen Llwyn Uchel
and it is adjoined to the Mynydd Pencarreg group of hills, which are situated in the south-western part of
South Wales (Region B, Sub-Region B1), and
it is positioned with a minor road to its immediate north, the A485 road to its
west and the B4337 road to its east, and has the town of Llanybydder towards
the north.
Extract from the Ordnance Survey 1:25,000 Explorer map |
When the original 300m height band of Welsh P30 hills were published on Geoff Crowder’s v-g.me website, this hill was included
in the accompanying Hills to be surveyed
sub list with a 381m summit height, based on the twin 381m spot heights that
appear on the Ordnance Survey 1:25,000 Explorer map, with the prioritised
summit positioned at SN 512 383 and with an accompanying note stating; Two tops of same height (SN517388 is 383m on
1985 1:50000 map).
Extract from the Ordnance Survey 1:50,000 Landranger map |
However, it was not until LIDAR became available
that the details for this hill could be accurately re-assessed. The LIDAR (Light Detection & Ranging)
technique produced highly accurate height data that is now freely available for
much of England and Wales.
LIDAR summit image of Pen Llwyn Uchel (SN 517 387) |
The summit height produced by LIDAR analysis is 383.45m
positioned at SN 51750 38783 and SN 51757 38784, with LIDAR giving 380.7m
positioned at SN 51229 38380 for the old prioritised summit, and this comes
within the
parameters of the Summit Relocations used within this page heading, these
parameters are:
The term Summit Relocations applies when the high
point of the hill is found to be positioned; in a different field, to a
different feature such as in a conifer plantation, within a different map contour, to a
different point where a number of potential summit positions are within close
proximity, when natural ground or the natural and intact summit of a hill is
confirmed compared to a higher point such as a raised field boundary or covered
reservoir that is considered a relatively recent man-made construct, or a
relocation of approximately 100 metres or more in distance from either the
position of a map spot height or from where the summit of the hill was
previously thought to exist.
Therefore, the summit height produced by LIDAR
analysis is 383.45m and this is positioned at SN 51750 38783 and SN 51757 38784,
this position is given a 381m spot height on the contemporary Ordnance Survey 1:25,000
Explorer map and a 383m spot height on the contemporary Ordnance Survey 1:50,000
Landranger map, and is approximately 550 metres north-eastward from where the origin
prioritised summit is positioned.
The full details for the hill are:
Group: Mynydd Pencarreg
Name: Pen Llwyn Uchel
OS 1:50,000 map: 146
Summit Height: 383.45m (LIDAR)
Summit Grid Reference (New Position): SN 51750 38783 & SN 51757 38784 (LIDAR)
Bwlch Height: 359.6m (LIDAR)
Bwlch Grid Reference: SN 52370 38728 (LIDAR)
Drop: 23.8m (LIDAR)
Myrddyn Phillips
(September 2023)
No comments:
Post a Comment