Lan Fach (SN 630 267)
There has been a Summit Relocation to a hill that is listed in the 100m Twmpau, with the summit height, bwlch height and their locations, the drop and status of the hill derived from LIDAR analysis conducted by Myrddyn Phillips.
LIDAR image of Lan Fach (SN 630 267) |
The criteria for the list that this summit
relocation applies to are:
100m Twmpau - Welsh hills at or above 100m and below 200m in height that have 30m
minimum drop, with an accompanying sub list entitled the 100m Sub-Twmpau, with
the criteria for this sub category being all Welsh hills at or above 100m and
below 200m in height with 20m or more and below 30m of drop, with the word Twmpau
being an acronym standing for thirty
welsh metre prominences and upward.
100m Twmpau by Myrddyn Phillips |
The name the hill is now listed by is Lan Fach and
this was derived from the Tithe map, and it is adjoined to the Mynydd
Mallaen group of hills, which are situated in the central
part of South Wales (Region B, Sub-Region B1), and it is positioned with minor roads to its north,
west, south and east, the A40 road farther to its south and the B4302 road
farther to its east, and has the town of Llandeilo towards the south.
When the original 100m height band of Welsh P30 hills were published on Geoff Crowder’s v-g.me website, this hill was not
included in the Hills to be surveyed
sub list, as it was considered not to meet the criteria then used for this sub
category.
After the sub list was standardised, and
interpolated heights and drop values also included the details for this hill
were re-assessed and it was listed with an estimated c 20m of drop, based on an
estimated c 181m summit height positioned at SN 631 267 and an estimated c 161m
bwlch height, with both heights based on interpolation of 10m contouring that
appear on the contemporary Ordnance Survey 1:25,000 Explorer map.
Extract from the Ordnance Survey 1:25,000 Explorer map |
However, it was not until LIDAR became available
that the details for this hill could be accurately re-assessed. The LIDAR (Light Detection & Ranging)
technique produced highly accurate height data that is now freely available for
much of England and Wales.
LIDAR analysis gives the highest ground on this
hill as 183.3m positioned at SN 63094 26744.
However, this is a part of a raised field boundary and protocols dictate
that as this is deemed a relatively recent man-made construct such ground is discounted
from the height of a hill.
LIDAR summit image of Lan Fach (SN 630 267) |
The height produced by LIDAR analysis to the highest
remaining natural ground of this hill is 182.6m and is positioned at SN 63091
26746, and this comes within the parameters of the Summit Relocations used within this
page heading, these parameters are:
The term Summit Relocations applies when the high
point of the hill is found to be positioned; in a different field, to a
different feature such as in a conifer plantation, within a different map contour, to a different
point where a number of potential summit positions are within close proximity,
when natural ground or the natural and intact summit of a hill is confirmed
compared to a higher point such as a raised field boundary or covered reservoir
that is judged to be a relatively recent man-made construct, or a relocation of
approximately 100 metres or more in distance from either the position of a map
spot height or from where the summit of the hill was previously thought to
exist.
Therefore, the height produced by LIDAR analysis to
the highest remaining natural ground of this hill is 182.6m and is positioned
at SN 63091 26746, this
position is not given a spot height on the contemporary Ordnance Survey
1:50,000 Landranger and 1:25,000 Explorer map, and is approximately 9 metres
north-westward from where the previously estimated summit position was given and
approximately 3 metres north-westward from where the high point of the raised
field boundary is positioned.
The full details for the hill are:
Group: Mynydd Mallaen
Name: Lan Fach
OS 1:50,000 map: 146
Summit Height: 182.6m (LIDAR)
Summit Grid Reference (New Position): SN 63091 26746 (LIDAR)
Bwlch Height: 159.1m (LIDAR)
Bwlch Grid Reference: SN 62212 26133 (LIDAR)
Drop: 23.4m (LIDAR)
Myrddyn Phillips (March
2024)
No comments:
Post a Comment