Crug yr Hwch (SN 173 325)
There has been a Summit Relocation to a hill that is listed in the The Welsh P15s, with the summit height, bwlch height and their locations, the drop and status of the hill derived from LIDAR analysis conducted by Myrddyn Phillips.
![]() |
| LIDAR image of Crug yr Hwch (SN 173 325) |
The criteria for the list that this summit relocation applies
to are:
The Welsh
P15s – Welsh hills with 15m
minimum drop, irrespective of their height, with an accompanying sub list entitled the Welsh Sub-P15s,
with the criteria for this sub category being all Welsh hills with 14m or more
and below 15m of drop. The list is authored by Myrddyn Phillips, with the
Introduction to the list appearing on Mapping Mountains on the 10th
May 2019.
![]() |
| The Welsh P15s by Myrddyn Phillips |
The name the hill is listed by is Crug yr Hwch,
and it is adjoined to the Mynydd Preseli group of hills, which are situated in the south-western part of
South Wales (Region B, Sub-Region B1), and
it is positioned with minor roads to its north, west and south, and the A478
road to its east, and has the town of Trefdraeth (Newport) towards the north-west.
When the listing that became known as The Welsh P15s was being compiled, this
hill was included in the main list with an estimated c 17m of drop, based on
the 318m summit spot height positioned at SN 17351 32530 that appears on the
Ordnance Survey 1:50,000 Landranger and 1:25,000 Explorer map and an estimated
c 301m bwlch height, based on interpolation of 5m contouring between 300m – 305m.
![]() |
| Extract from the Ordnance Survey 1:25,000 Explorer map |
However, it was not until LIDAR became available
that the details for this hill could be accurately re-assessed. The LIDAR (Light Detection & Ranging)
technique produced highly accurate height data that is now freely available for
much of England and Wales.
LIDAR analysis gives the highest ground on this
hill as 319.5m positioned at SN 17336 32490.
However, this is to the top of a raised field boundary and protocols
dictate that as this is deemed a relatively recent man-made construct such
ground is discounted from the height of a hill.
![]() |
| LIDAR summit image of Crug yr Hwch (SN 173 325) |
The height produced by LIDAR analysis to the
natural summit of this hill is 318.8m and is positioned at SN 17338 32531 and SN
17345 32540, and this comes within the parameters of the
Summit Relocations used within this page heading, these parameters are:
The term Summit Relocations applies when the high
point of the hill is found to be positioned; in a different field, to a
different feature such as in a conifer plantation, within a different map contour either on
Ordnance Survey maps or interactive mapping, to a different point where a
number of potential summit positions are within close proximity, when natural
ground or the natural and intact summit of a hill is confirmed compared to a
higher point such as a raised field boundary or covered reservoir that is
considered a relatively recent man-made construct, or the de-twinning of a
summit, or a relocation of approximately 100 metres or more in distance from
either the position of a map spot height or from where the summit of the hill
was previously thought to exist.
Therefore, the summit
height produced by LIDAR analysis is 318.8m and
is positioned at SN
17338 32531 and SN 17345 32540, this position is relatively close to where the
spot height appears on the contemporary Ordnance Survey 1:50,000 Landranger and
1:25,000 Explorer map and is approximately 50 metres northward from where the high
point of the raised field boundary is positioned.
The full details for the hill are:
Group: Mynydd Preseli
Name: Crug yr Hwch
OS 1:50,000 map: 145
Summit Height: 318.8m (LIDAR)
Summit Grid Reference (New Position): SN 17338 32531 & SN 17345 32540 (LIDAR)
Bwlch Height: 300.9m (LIDAR)
Bwlch Grid Reference: SN 17411 31829 (LIDAR)
Drop: 17.9m (LIDAR)
Myrddyn Phillips (May 2025)
%20-%20LIDAR%20hill%201.jpg)

%20-%201%2025000.jpg)
%20-%20LIDAR%20summit%202.jpg)
No comments:
Post a Comment