Cae Eithin (SO 096 286)
There has been a Summit Relocation to a hill that is listed in the The Welsh P15s, with the summit height, bwlch height and their locations, the drop and status of the hill derived from LIDAR analysis conducted by Myrddyn Phillips.
LIDAR image of Cae Eithin (SO 096 286) |
The criteria for the list that this summit relocation applies
to are:
The Welsh
P15s – Welsh hills with 15m
minimum drop, irrespective of their height, with an accompanying sub list entitled the Welsh Sub-P15s,
with the criteria for this sub category being all Welsh hills with 14m or more
and below 15m of drop. The list is authored by Myrddyn Phillips, with the
Introduction to the list appearing on Mapping Mountains on the 10th
May 2019.
The Welsh P15s by Myrddyn Phillips |
The name the hill is now listed by is Cae Eithin
and this was derived from the Tithe map, and it is adjoined to the Mynydd Epynt
group of hills, which are situated in the central
part of South Wales (Region B, Sub-Region B1), and it is positioned encircled by minor roads, with the
A470 road farther to its west and the A40 road farther to its south, and has
the town of Aberhonddu (Brecon) towards the west.
When the listing that became known as The Welsh P15s was being compiled, this
hill was listed with an estimated c 16m of drop, based on the 278m summit spot
height that is positioned at SO 09686 28687 and which appears on the contemporary
Ordnance Survey 1:25,000 Explorer map and an estimated c 262m bwlch height,
based on interpolation of 10m contouring between 260m – 270m.
Extract from the Ordnance Survey 1:25,000 Explorer map |
However, it was not until LIDAR became available
that the details for this hill could be accurately re-assessed. The LIDAR (Light Detection & Ranging)
technique produced highly accurate height data that is now freely available for
much of England and Wales.
LIDAR analysis gives the highest ground on this
hill as 278.9m positioned at SO 09665 28680.
However, this is to the top of a raised field boundary and protocols
dictate that as this is deemed a relatively recent man-made construct such
ground is discounted from the height of a hill.
LIDAR summit image of Cae Eithin (SO 096 286) |
The height produced by LIDAR analysis to the
natural summit of this hill is 278.6m and is positioned at SO 09665 28664 and SO
09667 28664, and this comes within the parameters of the Summit Relocations used
within this page heading, these parameters are:
The term Summit Relocations applies when the high
point of the hill is found to be positioned; in a different field, to a
different feature such as in a conifer plantation, within a different map contour, to a
different point where a number of potential summit positions are within close
proximity, when natural ground or the natural and intact summit of a hill is
confirmed compared to a higher point such as a raised field boundary or covered
reservoir that is judged to be a relatively recent man-made construct, or a
relocation of approximately 100 metres or more in distance from either the
position of a map spot height or from where the summit of the hill was
previously thought to exist.
Therefore, the summit
height produced by LIDAR analysis is 278.6m
and is positioned at SO 09665 28664 and SO 09667 28664, this position is not
given a spot height on the contemporary Ordnance Survey 1:50,000 Landranger and
1:25,000 Explorer map, and is approximately 23 metres south south-westward from
where the spot height appears on the Ordnance Survey 1:25,000 Explorer map and
importatly also positioned in a different field, and approximately 16 metres
southward from the high point of the raised field boundary.
The full details for the hill are:
Group: Mynydd Epynt
Name: Cae Eithin
OS 1:50,000 map: 161
Summit Height: 278.6m (LIDAR)
Summit Grid Reference (New Position): SO 09665 28664 & SO 09667 28664 (LIDAR)
Bwlch Height: 262.1m (LIDAR)
Bwlch Grid Reference: SO 09165 28809 (LIDAR)
Drop: 16.5m (LIDAR)
Myrddyn Phillips (July 2024)
No comments:
Post a Comment